Attaching and using the headset
You can listen to the FM Radio or the Music player in your phone with the supplied stereo headset
HDD-2.
Note: Your phone must be switched on to use this function. Do not switch the phone on when wireless
phone use is prohibited or when it may cause interference or danger.
To connect the HDD-2 headset
Insert the end of the black headset cable into the black connector (1) on
the left side of the phone. Similarly, insert the end of the headset cable
that is marked grey into the grey connector (2).
The headset lead functions as the antenna of the radio, so let it hang
freely.
Warning! Listening to music at a high volume may damage your
hearing. To adjust the volume level in the headset, press the Volume up or Volume down key on
the side of the phone.
©2002 Nokia Corporation. All rights reserved.
Get
ting
sta
rted
24
To use the headset to receive and make calls
To answer a call while using the headset, press the remote control button which is located in the
microphone part of the headset. To end the call, again press the same button.
If you have saved voice tags to certain phone numbers in your phone book, you can also make calls
using the headset. Press and hold the headset key until you hear a short tone. Say the voice tag. The
phone dials the corresponding phone number.
To receive calls with a headset other than HDD-2: On standby mode, press
(
Answer
). To divert or
reject the call, press
.You can listen to the caller’s voice in your headset, and you will need to talk
into the phone’s microphone. Note that it is always safest to use the HDD-2 headset.
■